# # This file configures the Piaware sdcard image # configuration. Whenever the system boots, this # file is read and its contents are used to # configure the system. # # Lines beginning with a '#' are comment lines # and are ignored. Blank lines are also ignored. # All other lines specify configuration settings. # # For simplicity, this file only shows the most common options. # For a complete list of options, see # https://flightaware.com/adsb/piaware/advanced_configuration # # NETWORK CONFIGURATION # # By default, PiAware will use DHCP when connecting to your network. # For other configurations, see the Advanced Configuration page # linked at the top of this file. # Should piaware use the wired ethernet port # for network access? wired-network yes # Should piaware use a wifi adaptor for network access? # If you are using a Pi 3, this will use the built-in wifi. # Otherwise, you will need to attach a supported USB wifi adaptor. wireless-network yes # Wifi SSID and password. # This should be changed to match your wireless # network SSID and, for networks that require # a passphrase, the passphrase. # # If your SSID or password contains characters other than # numbers and letters, such as the # character or whitespace, # you should enclose the value in quotation marks. For example, # "pass word" or "pass#word". # # To include quotation marks (") in a quoted value, use \" # To include a backslash (\) in a quoted value, use \\ wireless-ssid MyWifiNetwork wireless-password s3cr3t99 # # RECEIVER CONFIGURATION # # For a complete list of receiver types and their associated settings, # see the Advanced Configuration page linked at the top of this file. # For a receiver type of 'rtlsdr', this setting controls the dongle gain. # -10 means AGC / maximum gain; other values mean a gain value in dB. rtlsdr-gain -10 # # OTHER CONFIGURATION # # Should automatic system updates (initiated by FlightAware) be allowed? allow-auto-updates yes # Should manual system updates (initiated by you from the website control # panel) be allowed? allow-manual-updates yes # Should PiAware enable multilateration where possible? # You may need to disable this if multilateration overloads your receiver. allow-mlat yes # Should PiAware enable reception of Mode A/C messages when requested? # You may need to disable this if processing Mode A/C overloads your receiver. allow-modeac yes # Additional settings can be added below.